Lead2pass Cisco 300-360 VCE And PDF Instant Download:
After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?
A. The area is below the minimum threshold configured on the tool.
B. The area is below the detectable level and indicates no RF signal.
C. The area is below -100 dBm at coverage cell edge.
D. The area is below -67 dBm at coverage cell edge. » Read more
Lead2pass Offers Free 300-360 Dumps Files for Free Downloading By 300-360 Exam Expert:
An engineer is assigned to provide wireless coverage in a provincial capital building. Due to the age and historic nature of the building, the ability to run new copper Ethernet cable to desired AP locations is limited. Which requirement should the engineer specify to overcome this restriction?
A. Deploy access points where the survey indicates and connect them via fiber optic cable, using a mediaadapter, and locally provide power.
B. Deploy access points to each phone location converting two spare pairs of copper from the phone line toEthernet and locally provide power.
C. Deploy access point devices where limited cable can be run or exists and connect high-gain antennas andincrease Tx power to increase cell size.
D. Deploy RAP where limited cable can be run or exists, and extend coverage using MAP.
» Read more
Easily Pass 300-360 Exam With Lead2pass Updated Cisco 300-360 Dumps:
Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)
A. Use the Cisco wireless phone site survey client utility.
B. Use a separate Cisco Wireless Lan Controller.
C. Enable load balance on voice WLANs.
D. Maintain -67dBM as a minimal RSSI.
E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
F. Enable lower data rates for 2.4-GHz data WLAN.
» Read more
Lead2pass Dumps For Exam 300-360 With New Updated Exam Questions:
A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping.
How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?
A. No outer CAPWAP or inner QoS tagging is applied.
B. The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.
C. No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
D. The outer CAPWAP DHCP is marked and capped without any inner DSCP value.
» Read more
2017 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!
100% Free Download! 100% Pass Guaranteed!
I have already passed Cisco 300-360 certification exam today! Scored 989/1000 in Australia. SO MANY new added exam questions which made me headache….. Anyway, I finally passed 300-360 exam with the help of Lead2pass!
Following questions and answers are all new published by Cisco Official Exam Center: https://www.lead2pass.com/300-360.html
When reviewing a design for a voice over wireless deployment, what per-call bandwidth cost should be factored in when determining maximum calls per cell using SIP and G.711u as the codec?
A. 64 bytes
B. 8 bytes
C. 80 bytes
D. 10 bytes
» Read more