[PDF&VCE] Lead2pass New Updated 200-355 Braindump Free Get (151-160)
2016 September Cisco Official New Released 200-355 Dumps in Lead2pass.com!
100% Free Download! 100% Pass Guaranteed!
We offers the most current and best training materials of the 200-355 certification Q&A , Practice Software, Study Packs, Preparation Labs and Audio Training you are looking for. Our online certification training offers you quick and cost-efficient way to train and become a certified professional in IT industry.
Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/200-355.html
Which statement best describes the ability of a wireless client to access and transmit a data frame to an AP?
A. The client listens to the media until polled by the AP using PCF to send its data.
B. The client listens to the media until a data frame is finished, at which time it transmits, unless a collision
of data frames has occurred.
C. The client uses random countdown timers to start the transmission of a data frame.
D. The client listens to the media and countdown timers to start the transmission of a data frame.
Which statement about ZigBee technology is true?
A. It has low power consumption.
B. It is designed only for point-to-point communications.
C. It ranges up to 250 meters.
D. It supports data rates up to 1 and 2 Mb/s.
ZigBee is based on the IEEE 802.15.4 protocol for WPAN, and aims at developing hardware and applications with a low data rate but also low power consumption and low complexity –for example, to control sensors. ZigBee-based products can access up to 16 separate 5 MHz channels in the 2.4 GHz band and are not compatible with 802.11 devices. The maximum power of ZigBee is 60 mW. Devices use low.
Which four options are the characteristics of the original 802.11 protocol? (Choose four.)
A. Defined DSSS and FHSS as possiblemethods for modulation
B. Designed to operate in the 5 GHz ISM frequency spectrum
C. The most common deployment is three non-overlapping channels that are 20 MHz wide
D. The protocol sets the maximumthroughput at 1 Mb/s or 2 Mb/s
E. Defined FHSS and OFDM aspossible methods for modulation
F. The most common deployment is three non-overlapping channels that are 22 MHz wide
G. Designed to operate in the2.4 GHz ISM frequency spectrum
H. The protocol sets the maximum throughput at1 Mb/s
FHSS is still described in the original 802.11 protocol, but another technique was preferred and adopted by all 802.11 networks: Direct Sequence Spread Spectrum. Instead of small channels and a jumping sequence, the information is sent over a wider channel. This channel is 22 MHz wide (if the center frequency is 2.412, this channel spans from 2.401 GHz to 2.423 GHz) and does not move (no hopping, which is why the sequence is said to be direct instead of hopping). Then, over this 22 MHz channel, several bits of information are sent in parallel. If a source of interference affects part of the channel, it will prevent only the bits sent in that frequency from reaching the receiver.
Which two attacks does Management Frame Protection help to mitigate? (Choose two.)
B. Denial of Service
C. War Driving
The strength of our 200-355 dumps is the constant update that we perform to keep abreast with the market trends and changes. Our 200-355 exam question is not only the best option for certification but also enhances your skill to an advance level.
200-355 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDS2dtNHE0NWQwQzQ
2016 Cisco 200-355 exam dumps (All 410 Q&As) from Lead2pass:
http://www.lead2pass.com/200-355.html [100% Exam Pass Guaranteed]