[PDF&VCE] Latest Lead2pass 300-135 Exam Free 300-135 Dumps Download (11-20)

2016 October Cisco Official New Released 300-135 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Are you struggling for the 300-135 exam? Good news, Lead2pass Cisco technical experts have collected all the questions and answers which are updated to cover the knowledge points and enhance candidates’ abilities. We offer the latest 300-135 PDF and VCE dumps with new version VCE player for free download, and the new 300-135 dump ensures your 300-135 exam 100% pass.

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-135.html

Refer to the shown below.
%LINK-3-UPDOWN: Interface Serial0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
What statement is correct regarding the output shown in the graphic?

A.    These two log messages will not have a severity level.
They are not errors but are just informational messages.
B.    The first log message is categorized as a warning message.
C.    These messages regarding interface status are normal output and will always be displayed when you exit config mode.
D.    The first log message is an error message with a severity level of 3.
E.    The second message would be shown if the logging console warning command had been issued.

Answer: D

Refer to the configuration statements shown in the graphic above.
R1(config)#access-list 199 permit tcp host host
R1(config)#access-list 199 permit tcp host host
R1#debug ip packet 199 detail
Which statement reflects what the effect is of this configuration sequence?

A.    These commands will generate an error message because you cannot use an access list with any debug commands.
B.    These commands will have no effect at all. The debug ip packet command will work as normal and display info for all IP packets.
C.    These commands turn on debug ip packet only for packets between hosts and
D.     These commands will only work when you specify only one host rather than two.

Answer: C

What is the result if you configure two devices with the ntp server command?

A.    Nothing will happen until one of the devices is configured with the prefer parameter.
B.    The NTP protocol will determine which server is most reliable and will synchronize to that server.
C.    The device with the highest priority will become the active server and the other device will become the backup server.
D.    The device with the lowest MAC address will become the active server and the other device will become the backup server.

Answer: B

A technician is troubleshooting connectivity problems between two routers that are directly connected through a serial line. The technician notices that the serial line is up, but cannot see any neighbors displayed in the output of the show cdp neighbors command.
In which OSI layer is the problem most likely occurring?

A.    physical
B.    data link
C.    network
D.    transport
E.    application

Answer: B

What are two approaches to maintaining a network?(Choose two.)

B.    structured
C.    bottoms up
D.    interrupt-driven

Answer: BD

Which two statements about the Cisco Aironet Desktop Utility (ADU) are true? (Select two)

A.    The Aironet Desktop Utility (ADU) profile manager feature can create and manage only one profile for the wireless client adapter.
B.    The Aironet Desktop Utility (ADU) can support only one wireless client adapter installed and used at a time.
C.    The Aironet Desktop Utility (ADU) can be used to establish the association between the client adapter and the access point, manage authentication to the wireless network, and enable encryption.
D.    The Aironet Desktop Utility (ADU) and the Microsoft Wireless Configuration Manager can be used at the same time to configure the wireless client adapter.

Answer: BC

At which layer of the OSI model does the Spanning Tree Protocol (STP) operate at?

A.    Layer 5
B.    Layer 4
C.    Layer 3
D.    Layer 2
E.    Layer 1

Answer: D

In computer networking a multicast address is an identifier for a group of hosts that have joined a multicast group. Multicast addressing can be used in the Link Layer (OSI Layer 2), such as Ethernet Multicast, as well as at the Internet Layer (OSI Layer
3) as IPv4 or IPv6 Multicast. Which two descriptions are correct regarding multicast addressing?

A.    The first 23 bits of the multicast MAC address are 0x01-00-5E.
This is a reserved value that indicates a multicast application.
B.    The last 3 bytes (24 bits) of the multicast MAC address are 0x01-00-5E.
This is a reserved value that indicates a multicast application.
C.    To calculate the Layer 2 multicast address, the host maps the last 23 bits of the IP address into the last 24 bits of the MAC address. The high-order bit is set to 0.
D.    The first 3 bytes (24 bits) of the multicast MAC address are 0x01-00-5E.
This is a reserved value that indicates a multicast application.

Answer: CD

EIGRP is being used as the routing protocol on the Company network. While troubleshooting some network connectivity issues, you notice a large number of EIGRP SIA (Stuck in Active) messages. What causes these SIA routes? (Select two)
The neighboring router stops receiving ACK packets from this router.

A.    The neighboring router starts receiving route updates from this router.
B.    The neighboring router is too busy to answer the query (generally caused by high CPU utilization).
C.    The neighboring router is having memory problems and cannot allocate the memory to process the query or build the reply packet.

Answer: C

You want to enhance the security within the Company LAN and prevent VLAN hopping. What two steps can be taken to help prevent this? (Select two)

A.    Enable BPD guard
B.    Disable CDP on ports where it is not necessary
C.    Place unused ports in a common unrouted VLAN
D.    Prevent automatic trunk configuration
E.    Implement port security

Answer: CD

We ensure our new version 300-135 PDF and VCE dumps are 100% valid for passing exam, because Lead2pass is the top IT certification study training materials vendor. Many candidates have passed exam with the help of Lead2pass’s VCE or PDF dumps. Lead2pass will update the study materials timely to make them be consistent with the current exam. Download the free demo on Lead2pass, you can pass the exam easily.

300-135 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDMVBfSHZ4UzJTOVk

2016 Cisco 300-135 exam dumps (All 87 Q&As) from Lead2pass:

http://www.lead2pass.com/300-135.html [100% Exam Pass Guaranteed]

Why Choose Lead2pass?

If you want to pass the exam successfully in first attempt you have to choose the best IT study material provider, in my opinion, Lead2pass is one of the best way to prepare for the exam.

Lead2pass Testking Pass4sure Actualtests Others
$99.99 $124.99 $125.99 $189 $29.99-$49.99
Real Questions
Error Correction
Printable PDF
Premium VCE
VCE Simulator
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back